ABB 2CDS243001R0324 ABB System pro M Miniature Circuit Breakers

Razz Middle East supplies ABB System pro M miniature circuit breakers in Saudi Arabia, sourced to order against the 2CDS catalogue reference. These are the S200-family MCBs that protect final circuits in distribution boards, control panels and machine cabinets, together with their auxiliary contacts, add-on residual current blocks and busbar sets. Quoted per part number, delivered duty-paid, with a typical lead time of three weeks.

ABB 2CDS243001R0324

This page covers ABB part number 2CDS243001R0324 — ABB System pro M Miniature Circuit Breakers. Quote the full part number with your enquiry and the item is unambiguous: one part number identifies one exact product variant, including options that are not visible in the description.

About ABB System pro M Miniature Circuit Breakers

The S200 family is built around one 17.5 mm-per-pole body offered in one, two, three and four poles, with S201, S202, S203 and S204 denoting the pole count. Rated currents run from fractions of an ampere up to 63 A, and the tripping characteristic is chosen by curve letter: B for resistive and long cable runs, C as the general-purpose choice for mixed loads, D for transformer, motor and other high-inrush circuits, with K and Z curves available for motor and electronic-equipment protection respectively. Short-circuit breaking capacity is the other selection axis — the standard series is rated at 6 kA, while the reinforced S200M and S200P versions are rated higher, up to the 25 kA class.

The same body accepts a set of add-ons that share the reference block: auxiliary and signal contacts that report the breaker's state to a control system, shunt trips and undervoltage releases, and DDA-type residual current blocks that turn an MCB into a leakage-protecting device without changing the board layout. Pin and fork busbars connect a row of breakers to a common incomer. The 2CDS reference records exactly which pole count, current, curve and breaking class you are getting.

ABB System pro M Miniature Circuit Breakers in Saudi Arabia

S200 breakers are the standard final-circuit device across Saudi construction and industry. They fill consumer units and distribution boards in residential and commercial buildings, control-panel supplies in factories, and small-power and lighting sub-boards on projects from Riyadh office towers to Red Sea resort packages and the early NEOM buildings. Curve selection matters more here than in cooler climates: air-conditioning compressors and inverter units draw a high inrush, so C and D curves dominate on those circuits while lighting and socket circuits stay on B and C. Breaking capacity is a real question near a large SEC substation, where prospective fault current can exceed a 6 kA device's rating. Industrial users in Jubail, Yanbu and at cement and food plants use the same breakers for control-circuit and instrument-supply protection. Imported devices on regulated projects are subject to SASO conformity; boards are built for a 380/400 V, 60 Hz supply.

Ordering and lead time

Give the full 2CDS reference. The numbers are close together on purpose — 2CDS251001R0165, 2CDS252001R0254, 2CDS253001R0517 and 2CDS273317R0517 differ in pole count, rated current, curve and breaking class — and reading the front marking off an installed breaker is the fastest way to get an exact match. If you are specifying rather than replacing, tell us pole count, rated current, tripping curve and the breaking capacity required at that board, and note whether you need an add-on auxiliary contact, shunt trip or residual current block, since those are separate references that must be compatible with the breaker series. Busbar comb sets are sized by pole pitch and number of ways, so give the board layout. Everything in this group is sourced to order, with a typical lead time of three weeks, delivered duty-paid to site.

Specifications are taken from the supplier's published catalogue data. Confirm against the manufacturer's current datasheet before ordering.