BTicino BMSA1104 BTicino Building Automation Modules

Razz Middle East supplies BTicino building automation modules in Saudi Arabia, sourced to order against the code you quote. These are the bus-connected devices behind a controlled installation: actuators that switch lighting and drive shutters, control and scenario interfaces, and the power supply and interface modules that support them. Orders are delivered duty-paid to site, with a typical lead time of three weeks.

BTicino BMSA1104

This page covers BTicino part number BMSA1104 — BTicino Building Automation Modules. Quote the full part number with your enquiry and the item is unambiguous: one part number identifies one exact product variant, including options that are not visible in the description.

About BTicino Building Automation Modules

BTicino's automation modules work on a dedicated low-voltage bus rather than on conventional switch wiring: control devices and actuators share a two-wire cable, and a command is addressed to an actuator instead of being carried by the switch that generated it. The practical consequence is that a load is switched at the actuator, usually mounted on DIN rail in a board or hidden in a ceiling void, while the wall device is only an input. Codes in this family are letter-prefixed and grouped by module type — BMSA1105, BMSA2205, BMSW1003, BMSW3002 — with the digits distinguishing variants within the group, typically by channel count and physical format. Devices in the range include multi-channel relay actuators for lighting circuits, actuators for roller shutters and blinds, dimming outputs, control and scenario interfaces, contact interfaces that bring conventional inputs onto the bus, and bus power supplies. Configuration is done through the system's own tools and addressing scheme, so the module must match the generation of the installation it is joining. That compatibility question is the one to settle before a module is ordered, not after it is delivered.

BTicino Building Automation Modules in Saudi Arabia

Bus-based lighting and shutter control is specified in Saudi Arabia mainly at the upper end of residential and hospitality work: private villas and palaces in Riyadh and Jeddah, majlis and reception areas where scene control is wanted, hotel guest rooms and lobbies, and the newer Red Sea and NEOM hospitality projects. It also appears in offices and showrooms where a floor's lighting is grouped and timed centrally. A large share of enquiries is expansion or repair of an installation already in place: a villa adds a wing, an actuator channel has failed, or a control interface has to be replaced without reconfiguring the whole system. Loads are switched at 220/230 V, 60 Hz, and the bus itself runs at extra-low voltage on its own cable. Devices placed on the Saudi market are subject to SASO conformity requirements, and the wall-mounted parts of the system share the same flush boxes as the standard civil ranges.

Ordering and lead time

Quote the module code in full, and tell us what the module is joining. For an expansion or a repair, name the system generation already installed and the codes of the devices around it, because bus modules from different generations are not always interchangeable and a mismatch is discovered on site, not on paper. State the number of channels you need, whether the module is to sit on DIN rail in a board or behind a wall plate, and what it will switch — lighting circuits, shutter motors or dimmed loads all take different actuators. If the installation is being extended, count the modules against the capacity of the existing bus power supply before ordering. Everything is sourced to order and delivered duty-paid, with a typical lead time of three weeks from confirmation of the codes.

Specifications are taken from the supplier's published catalogue data. Confirm against the manufacturer's current datasheet before ordering.