Finder 7M.24.8.230.0210 Finder 7M Series Energy Meters

Razz Middle East supplies Finder 7M series energy meters in Saudi Arabia, sourced to order against the full dotted code. These are DIN-rail kilowatt-hour meters for single-phase and three-phase circuits, fitted in distribution boards to measure consumption on a feeder, a tenancy, a department or a single large load. Items are ordered by the complete code and delivered duty-paid, normally within three weeks.

Finder 7M.24.8.230.0210

This page covers Finder part number 7M.24.8.230.0210 — Finder 7M Series Energy Meters. Quote the full part number with your enquiry and the item is unambiguous: one part number identifies one exact product variant, including options that are not visible in the description.

About Finder 7M Series Energy Meters

The 7M code follows the same five-field Finder structure as the rest of the catalogue: series, type, supply variant, voltage and options. In 7M.24.8.230.0001 the 24 identifies a single-phase meter body and 230 the nominal supply, while 7M.38.8.400.0112 is a three-phase type at 400 V. The final option group is where the meters differ most, and it is not padding: it distinguishes a plain display-only meter from versions with a pulse output for a building management system, versions with a communication interface such as Modbus or M-Bus, and versions with different measurement and tariff functions. Direct-connected types measure the load current through the meter itself, while transformer-connected types are used above that where current transformers carry the load, and the two are not interchangeable. Module width on the rail follows the phase count. Meters intended for billing carry a separate metrological approval from meters intended for internal sub-metering, and that distinction is part of the type rather than a setting.

Finder 7M Series Energy Meters in Saudi Arabia

Sub-metering has become routine in the Kingdom as facilities are asked to allocate energy cost and to report consumption. Commercial buildings, malls, hotels and mixed-use developments in Riyadh and Jeddah fit meters on tenant feeders and on major plant such as chillers, pumps and lift banks. Industrial sites and Ma'aden, cement and food plants meter departments and large drives so that consumption can be tied to production. District cooling schemes meter plant rooms. Facilities teams in hospitals, universities and government buildings use pulse or Modbus outputs to feed a building management system rather than reading meters by hand. Distribution is 230 V single phase and 400 V three phase at 60 Hz, so the supply voltage field in the code needs checking against the board rather than copied from a European specification, and imported equipment must satisfy the applicable SASO conformity requirements.

Ordering and lead time

Quote all five fields of the code including the final option group, since that group is what carries the output and communication version. State whether the circuit is single-phase or three-phase, the nominal voltage at the board, and the maximum load current, so the meter is specified as direct-connected or transformer-connected. If current transformers are used, say what ratio is installed. Say whether you need a pulse output, a Modbus or M-Bus interface, or display only, and whether the reading has to be used for billing a third party, because that changes which approval the meter must carry. Confirm the free module width on the rail. Items are sourced to order and delivered duty-paid, with a normal lead time of three weeks.

Specifications are taken from the supplier's published catalogue data. Confirm against the manufacturer's current datasheet before ordering.