Moxa ICF-1150-M-SC-T Moxa Industrial Networking and Serial Connectivity

Razz Middle East supplies Moxa industrial networking hardware into Saudi Arabia on an order basis. The family covers NPort serial device servers, TCC serial converters and TCF fibre converters, ioLogik remote input and output units, and DIN-rail Ethernet switches. These are the parts that carry Modbus, serial and Ethernet traffic between field cabinets and a control room. Units are sourced to order against the full model name and delivered duty-paid.

Moxa ICF-1150-M-SC-T

This page covers Moxa part number ICF-1150-M-SC-T — Moxa Industrial Networking and Serial Connectivity. Quote the full part number with your enquiry and the item is unambiguous: one part number identifies one exact product variant, including options that are not visible in the description.

About Moxa Industrial Networking and Serial Connectivity

The four groups here do different jobs and are not interchangeable. NPort device servers put a serial port on an Ethernet network. They are ordered by port count, by the serial standards the port supports, and by whether the host application will use a virtual COM driver, a raw TCP socket or a Modbus gateway mode, since not every model offers all three. TCC converters change one serial standard into another, most often RS-232 into RS-422 or RS-485, and the I in a model name marks the isolated version, which is what a long cable run between two separately earthed cabinets needs. TCF converters carry serial signals over fibre; the model name states the fibre mode and connector, so an ST multimode unit will not mate with an SC single-mode patch. ioLogik units are remote input and output blocks that report over Ethernet or Modbus RTU rather than sitting on a PLC backplane, and they are chosen by channel mix rather than by protocol alone. Across all four groups a T suffix marks the wide-temperature build, and power input varies between low-voltage DC and mains-rated models.

Moxa Industrial Networking and Serial Connectivity in Saudi Arabia

Most Moxa hardware in the Kingdom is doing one of two jobs: bringing old serial field devices onto an Ethernet SCADA system, or extending a network beyond what copper can carry. Water and wastewater utilities, desalination plants and SEC distribution assets run many Modbus RTU meters, protection relays and flow computers that were never designed for Ethernet, and a device server or Modbus gateway is the usual way to reach them. Fibre converters are used where cable runs cross a plant road or a switchyard and copper would pick up interference or a potential difference. Oil and gas gathering systems, tank farms and pipeline stations use remote input and output blocks at unmanned sites. Cabinet temperature is the practical constraint. An outdoor field cabinet in the Eastern Province sits well above ambient in summer, so the wide-temperature build is the sensible default for anything mounted outside an air-conditioned room, and power supplies should be sized with that derating in mind.

Ordering and lead time

Quote the full model name, not the family. NPort, ioLogik and EDS each cover many series with different port counts, protocols and enclosures, and a request naming only the family cannot be quoted accurately. Give the exact string from the label, including any T for wide temperature and any I for isolation. For fibre converters, state the fibre mode, the connector type and the distance the link has to run, because those three decide the model. For device servers, say how many serial ports are needed, which serial standard each port must speak, and whether the host will use a virtual COM port or a Modbus gateway. Confirm the power input available in the cabinet. Razz sources Moxa units to order with a lead time of about three weeks, delivered duty-paid to sites across the Kingdom.

Specifications are taken from the supplier's published catalogue data. Confirm against the manufacturer's current datasheet before ordering.