Schneider Electric NSYSUCR4060 Spacial and Thalassa Enclosures and Accessories

Razz Middle East supplies Schneider Electric Spacial and Thalassa enclosures and accessories across Saudi Arabia — wall-mounting and floor-standing cabinets, mounting plates, gland plates, thermal management and the internal fittings that turn an empty box into a working panel. Every item is sourced to order against the reference you quote and delivered duty-paid to your site. Typical lead time is three weeks from order confirmation.

Schneider Electric NSYSUCR4060

This page covers Schneider Electric part number NSYSUCR4060 — Spacial and Thalassa Enclosures and Accessories. Quote the full part number with your enquiry and the item is unambiguous: one part number identifies one exact product variant, including options that are not visible in the description.

About Spacial and Thalassa Enclosures and Accessories

NSY references cover the enclosure programme and the very large accessory range that goes with it. The enclosures themselves split by material and duty: sheet steel for indoor and protected installations, stainless steel where corrosion or wash-down is a factor, and glass-reinforced polyester for outdoor and chemically aggressive environments. Within each, the reference encodes the physical size and the protection rating, and those two numbers are the ones that must match your drawing.

The accessories are where most of the reference count sits. Mounting plates, DIN rail sets, gland plates, cable entry systems, door stays, locks and inserts, plinths, thermostats, heaters, filter fans and roof canopies all carry their own NSY reference and all are sized to a specific enclosure. An accessory is not universal within the range: a mounting plate for one cabinet width does not fit the next size up. That is why an enclosure order is usually a short bill of materials rather than a single line, and why it is worth listing the whole assembly at enquiry stage.

Spacial and Thalassa Enclosures and Accessories in Saudi Arabia

Enclosure selection is where Saudi conditions bite hardest, because the enclosure is the only thing between the equipment and the environment. Outdoor panels face direct sun, blown sand, and in coastal areas at Jubail, Yanbu, Jazan and along the Red Sea, salt-laden humidity that attacks painted steel at cut edges and hinge points. Stainless and GRP are specified for those locations not as an upgrade but because painted steel does not survive.

Solar gain is the other constraint, and it is routinely underestimated. An outdoor panel in direct sun can run far above ambient, and the equipment inside — drives, power supplies, PLCs — derates or fails at temperatures the enclosure alone does not control. That is why thermal accessories in this range matter as much as the box: sunshields and roof canopies to stop radiant gain, filter fans or air conditioners to move heat out, and thermostats to control them. Ingress protection and thermal management pull against each other, since a sealed enclosure cannot ventilate, and resolving that trade-off is the real design decision.

Ordering and lead time

For an enclosure, tell us the external dimensions or the reference, the material, the protection rating you need and whether it is indoor or outdoor. If it is outdoor, say so explicitly and tell us the location — coastal and inland desert sites lead to different material recommendations, and it is cheaper to get that right at order stage than after a season.

For accessories, quote the enclosure reference or its exact dimensions as well as the accessory reference. Accessories are sized to specific enclosures and a mounting plate or gland plate for the wrong width is simply scrap. If you are fitting out a cabinet, list everything you need in one enquiry — plate, rails, gland plate, thermal parts, locks — because these ship together and quoting them as one order shares the import and clearance cost across the whole list instead of repeating it. Typical lead time is three weeks from order confirmation, and items are supplied to order and delivered duty-paid.

Specifications are taken from the supplier's published catalogue data. Confirm against the manufacturer's current datasheet before ordering.