Schneider Electric RXG22BD Zelio RXG Interface Relays

Razz Middle East supplies Schneider Electric Zelio RXG plug-in interface relays across Saudi Arabia — a narrow, specific range within the wider Zelio relay line, used to isolate a low-power control signal from the circuit it switches. Each reference is sourced to order against the part number you quote and delivered duty-paid to your site. Typical lead time is three weeks from order confirmation.

Schneider Electric RXG22BD

This page covers Schneider Electric part number RXG22BD — Zelio RXG Interface Relays. Quote the full part number with your enquiry and the item is unambiguous: one part number identifies one exact product variant, including options that are not visible in the description.

About Zelio RXG Interface Relays

RXG sits inside the Zelio interface relay line, a narrower and more specialised range than the general-purpose RXM miniature relays covered separately in this catalogue. An RXG relay's job is interfacing rather than everyday switching: it separates a low-power output from a PLC, sensor or control card from the device that output needs to operate, or steps between circuits running at different voltages or currents. Like the rest of the Zelio plug-in system, the relay body pushes into a socket rather than being hard-wired, so a failed unit is pulled and replaced without disturbing the field wiring behind it.

The references Razz supplies span different contact arrangements and coil voltages, AC and DC, reflecting the range of signals RXG interfaces with. Because the family is narrow, what matters at order stage is rarely a choice between RXG variants — it is matching the exact reference on the device you are replacing. RXG sockets and accessories are not interchangeable with the RXM range.

Zelio RXG Interface Relays in Saudi Arabia

RXG relays appear wherever a Saudi panel builder needs to interface a PLC or control card output to a field device without loading that output directly — signal isolation in control rooms, interposing relays ahead of larger contactors, and voltage-stepping between a 24 V control rail and a different field voltage. This is common practice on process and utility sites across Jubail, Yanbu and the wider Eastern Province, where control cabinets are built to keep sensitive controller outputs isolated from anything carrying an inductive load.

Because RXG is plug-in, it is usually specified where a builder wants a relay that can be swapped without rewiring, during commissioning or after a fault. As with any plug-in relay, correct coil voltage matters more than most other selections: getting it wrong produces a relay that either will not energise or runs stressed continuously.

Ordering and lead time

Quote the full RXG reference exactly as printed on the relay body. The reference is short but dense — it encodes the contact arrangement and the coil voltage together, and a relay that looks physically similar to the one you are replacing can carry a different coil. If you are unsure, a photograph of the label is the fastest way to confirm it.

Tell us whether you also need the matching socket, since a relay on its own cannot be wired into a panel. If you are populating a new panel rather than replacing a single unit, list the full set of references together so we can confirm compatibility across relay and socket before the order is placed. Typical lead time is three weeks from order confirmation, and items are supplied to order and delivered duty-paid.

Specifications are taken from the supplier's published catalogue data. Confirm against the manufacturer's current datasheet before ordering.