Legris 3104 Legris Pneumatic Fittings and Tube Connectors

Razz Middle East supplies Legris pneumatic fittings and tube connectors across Saudi Arabia. The range covers push-in fittings in straight, elbow, tee and bulkhead forms, function fittings such as flow regulators and non-return valves, manifolds, and the tubing that runs between them. Items are sourced to order against the exact Legris reference and delivered duty-paid to site.

Legris 3104

This page covers Legris part number 3104 — Legris Pneumatic Fittings and Tube Connectors. Quote the full part number with your enquiry and the item is unambiguous: one part number identifies one exact product variant, including options that are not visible in the description.

About Legris Pneumatic Fittings and Tube Connectors

A push-in fitting is defined by two independent dimensions and one material decision. The tube side is sized by the outside diameter of the tube, in metric or imperial series, and metric and imperial tubes of nominally similar size are not interchangeable in the same collet. The port side is a thread, and the thread form matters as much as the size: a parallel thread seals on a washer or an O-ring at the face, while a tapered thread seals on the thread flanks and needs a sealant or a pre-applied coating. Fitting a parallel thread into a tapered port, or the reverse, gives a joint that appears tight and leaks under pressure. Body material is chosen for the environment, with nickel-plated brass as the general case, stainless steel where corrosion or washdown demands it, and technopolymer where weight and cost dominate. Function fittings integrate a flow regulator, a check valve or a silencer into the connection itself, which removes an inline component from a cylinder port.

Legris Pneumatic Fittings and Tube Connectors in Saudi Arabia

Compressed air is present in nearly every Saudi production facility, and these fittings are the consumable layer of that system. Food and beverage, dairy, bottling and packaging plants around Riyadh, Jeddah and Al Kharj use them on cylinder, valve island and air preparation connections. Plastics processing, woodworking, printing and general machine shops use the same range, and cement, mining and petrochemical sites use air on instrumentation, actuators and dust-handling equipment. Two local factors shape material choice. High ambient temperature and ultraviolet exposure degrade unprotected polyurethane tubing on external runs, so routing and tube material should be reviewed on any outdoor circuit. In washdown areas, particularly food and dairy, stainless bodies and appropriate tube materials resist the cleaning chemicals that attack plated brass. Air quality also matters: water and oil carryover in a hot, humid coastal plant shortens seal life inside the fittings.

Ordering and lead time

Quote the Legris reference as printed on the packaging, for example 7010-06-10 or a series number such as 3102, and state the quantity, since these are volume consumables normally supplied in packs. If the reference is not available, give the three defining values: tube outside diameter with the series stated as metric or imperial, thread size, and thread form as parallel or tapered. Add the body material required and note whether the application is a washdown or food-contact area. For function fittings, say what the fitting must do, such as meter-out speed control on a cylinder exhaust, and give the cylinder port thread. Tubing is ordered by outside diameter, wall thickness, material and coil length. Items are sourced to order with a typical lead time of three weeks and delivered duty-paid to site.

Specifications are taken from the supplier's published catalogue data. Confirm against the manufacturer's current datasheet before ordering.