Norgren 840014-52KIT Norgren Pneumatics and Fluid Control

Razz Middle East supplies Norgren pneumatic and fluid control components across Saudi Arabia. The range covers ISO profile and rodless actuators from the M/ series, B-series filters, regulators and lubricators for air preparation, solenoid and process valves, and VPPC proportional pressure regulators. Every part is sourced to order against the code you quote and delivered duty-paid to your site, normally within about three weeks.

Norgren 840014-52KIT

This page covers Norgren part number 840014-52KIT — Norgren Pneumatics and Fluid Control. Quote the full part number with your enquiry and the item is unambiguous: one part number identifies one exact product variant, including options that are not visible in the description.

About Norgren Pneumatics and Fluid Control

Norgren builds compressed-air and fluid handling hardware for factory and process plant. Four groups cover most of what a maintenance store carries. Actuators: the M/ series spans ISO 15552 profile and tie-rod cylinders, compact and short-stroke bodies, rodless designs and guided units, with bore and stroke encoded in the number, so M/1714/63 identifies a body type followed by its bore in millimetres. Air preparation: the B-series filters, regulators, lubricators and combination units, of which B82G-3GK-QP3-RMG is one build, where the trailing characters fix port thread, filtration grade, adjustment range, drain type and whether a gauge is fitted. Valves: solenoid and pilot-operated spool valves, poppet valves, manifold-mounted islands, and Buschjost-branded process and angle-seat valves for steam, water and chemical duty. Proportional control: the VPPC family, closed-loop electronic pressure regulators taking an analogue or fieldbus setpoint, used where a pressure has to be held or ramped rather than simply switched. Norgren also supplies fittings, tubing, silencers, air dryers and repair kits, so a single order line often pairs a seal kit with the actuator it belongs to.

Norgren Pneumatics and Fluid Control in Saudi Arabia

Pneumatics do most of the mechanical work in Saudi plants that do not run hydraulics. Norgren hardware turns up on packaging and filling lines in food and beverage factories in Riyadh and Jeddah, on bagging and palletising equipment at cement works, and on valve actuators, dampers and knife gates in petrochemical units at Jubail and Yanbu. Water and desalination sites use pneumatic actuation on filter backwash and isolation valves, where instrument air quality decides how long a seal lasts. Conditions in the Kingdom are hard on air systems: high summer temperatures raise the dew point, and airborne dust shortens filter element life, so air preparation units and their elements are replaced far more often here than in temperate plants. Control panels run from 380/400 V, 60 Hz supply, and solenoid coils are usually specified at 24 V DC from the panel, or 220/230 V AC where local control is wired direct. Equipment entering the Kingdom is subject to SASO conformity requirements.

Ordering and lead time

Quote the complete Norgren part number, including every suffix. On a B-series air preparation unit the characters after the body code set port size, filter grade, regulator range, drain type and gauge fitting, so B82G-3GK-QP3-RMG and a similar-looking neighbour are not interchangeable. On an M/ series cylinder the bore, stroke, mounting and cushioning all sit inside the code, and a stroke that does not match will not fit the machine. VPPC proportional regulators differ by pressure range, signal type and connector. If the marking is worn off, send a photograph of the label, the machine or OEM reference and, for actuators, the measured bore and stroke. Items are sourced to order and no stock is held in Saudi Arabia; the normal lead time is about three weeks, delivered duty-paid to your site with clearance settled.

Specifications are taken from the supplier's published catalogue data. Confirm against the manufacturer's current datasheet before ordering.