SKF FYT 1.3/8.FM Pillow Block Unit

The SKF FYT 1.3/8.FM Pillow Block Unit is a ready-to-mount two-bolt pillow block unit from SKF, combining a self-aligning Y-bearing (insert bearing) with a cast or pressed housing for a shaft of approximately 1.3/8 in mm. The unit is supplied pre-lubricated and sealed, allowing rapid installation on conveyors, fans, agitators and general shaft-line equipment without separate bearing fitting. The spherical outer-ring seat accommodates initial shaft misalignment, simplifying alignment during commissioning.

SKF Y-bearing units feature integral contact seals that exclude the fine sand and dust common across Saudi industrial sites, while the relubrication facility extends grease life under the high ambient temperatures of the Kingdom. The grub-screw or eccentric-collar locking secures the bearing to the shaft, and the housing material is selected for strength and corrosion resistance in coastal Eastern Province and inland Riyadh installations alike.

These units are widely used in Saudi Arabia at facilities such as NEOM (green hydrogen plant rotating equipment) and SAFCO (ammonia plant compressor bearings), supporting belt conveyors, ventilation fans, packaging lines and water-treatment equipment across the mining, cement, food, desalination and general manufacturing sectors. They are SASO compliant and accepted on major Saudi approved vendor lists.

Razz Middle East stocks SKF Y-bearing units, insert bearings and matching housings for fast supply across Saudi Arabia, with delivery to Jubail, Dammam, Riyadh, Jeddah and Yanbu typically within 24 to 48 hours for stocked sizes. Contact Razz Middle East at sales@razz.sa to request a quotation for the FYT 1.3/8.FM, confirm stock, or obtain technical selection support for your application in Dammam.

The Kingdom of Saudi Arabia's industrial expansion under Vision 2030 — spanning new refining and petrochemical capacity, the NEOM and Red Sea giga-projects, expanded desalination and water-transmission networks, and growing mining output at MAADEN — is placing record demands on the reliability of rotating equipment. Operators at sites such as Saudi Aramco (Khurais water injection facility) increasingly rely on genuine SKF components and correct maintenance practice to maximise asset availability, reduce energy consumption and avoid the high cost of unplanned shutdowns. Counterfeit and non-OEM parts remain a real risk in the regional market, so sourcing authentic SKF products through an established distributor protects both equipment and warranty coverage. Razz Middle East supplies only genuine SKF product backed by full traceability and SASO documentation, with experienced technical staff able to advise on selection, interchange and application for the demanding conditions of the Saudi market.